Digga PDT50 2-Speed Auger Drive

Digga PDT50 2-Speed Auger Drive

The Digga PDT50 is a 2-speed hydraulic auger drive for 20 to 28 tonne excavators, built for pendulum drilling. It runs on 40 to 180 L/min and gives up to 40,061 Nm of torque @ 240 Bar, with augers up to 1,800 mm in earth and 1,500 mm in clay.

  • High speed suits small augers, lifting spoil quickly and leaving a clean base. Switch to low speed and high torque to push large augers through compacted ground and rock.
  • Two speeds let it carry a bigger reduction gearbo... Read more

Delivery Information

– 2-5 business days for products in stock that don’t require any customisation
– 5-10 business days for products that require a custom fitting to your machine type

Availability: In Stock
$18,172.00
Wishlist Compare

The Digga PDT50 is a 2-speed hydraulic auger drive for 20 to 28 tonne excavators, built for pendulum drilling. It runs on 40 to 180 L/min and gives up to 40,061 Nm of torque @ 240 Bar, with augers up to 1,800 mm in earth and 1,500 mm in clay.

  • High speed suits small augers, lifting spoil quickly and leaving a clean base. Switch to low speed and high torque to push large augers through compacted ground and rock.
  • Two speeds let it carry a bigger reduction gearbox than a single-speed drive, so you keep high torque for most of the hole.
  • HALO alignment comes standard, so the operator can see when the drive is plumb without a spotter.
  • Cradle or double pin hitch, or no frame. 100 mm square output shaft for Digga 10 and 11 Series augers.

Warranty is 5 years on the gearbox and 3 years on the motor. Your machine needs a case drain line, and the 2-speed controller is sold separately. Tell us your machine make and model when you order, and we'll check it fits before anything is ordered.